Skip to Main Content

Pilot Light Keeps Going Out on Your Altamonte Springs Gas Water Heater? When to Call for Repair

by Sheila Beasley · 5 min read

Plumber uses a flashlight to inspect the lower burner compartment of a gas water heater in a garage.

A pilot light that keeps going out usually points to a worn thermocouple, a dirty pilot assembly, a clogged air intake, or a failing gas control valve. All of these are repairable. If you smell gas, though, stop using the heater and treat it as an emergency, not a repair.

Relighting the pilot over and over is a sign something is wrong, not a fix. A licensed plumber can find the cause and handle the gas side safely. To schedule gas water heater repair, contact our team or call (407) 273-6260.

What makes a gas water heater pilot light keep going out?

The most common cause is a weak thermocouple. That small sensor sits in the pilot flame and tells the gas valve it's safe to stay open. When it wears out, the valve shuts the gas off even though the flame was lit, so the pilot keeps dying.

A dirty pilot assembly is next. Dust, lint, and rust can choke the tiny pilot opening and shrink the flame until it can't heat the thermocouple. Newer tanks also have a flame arrestor screen at the bottom that pulls in air. When it clogs with garage dust or dryer lint, the burner can starve and shut down.

The gas control valve itself can fail, too. If the thermocouple and pilot check out but the flame still won't hold, the valve is often the culprit. A strong draft from an open garage door can also blow out a weak flame.

Many of the 1970s and 1980s homes in Spring Oaks and the Sanlando area still have the heater in a garage or utility closet where dust builds up fast. Our water heaters page covers the repairs we handle, often the same day.

Which symptoms mean you should stop using it and call right away?

Any gas smell means stop. Leave the house, don't flip switches or use your phone inside, and call your gas provider from outside. Then call a licensed plumber. A pilot problem plus a gas odor is never something to troubleshoot yourself.

Other red flags need a pro soon, even without a smell. Watch for a yellow or lazy, flickering flame instead of a steady blue one, soot or scorch marks around the burner opening, a hissing sound near the gas valve, or water pooling under the tank. Rusty hot water can mean the tank lining is failing.

Running out of hot water faster than usual is the quieter warning. Sediment from years of heating builds up in the bottom of the tank, which makes the burner work harder and can add to pilot trouble.

Condo and townhome owners around Cranes Roost should be extra careful. Shared walls and a water heater tucked in a closet leave little room for error with gas. We're licensed for the gas work, and we coordinate with your HOA when a job needs it.

Is it time to repair or replace an older gas water heater?

Repair makes sense for a tank under about eight years old with one clear problem, like a bad thermocouple or a dirty pilot. Replacement usually makes more sense for a tank over ten years old, one that's needed several repairs, or any tank that's leaking.

One customer reluctantly admitted he'd been taking fewer showers because he had to check the water heater every time. The pilot light kept going out. We inspected the heater, found what was going on, and talked with him about how to repair it.

That's how we handle every call. We diagnose first and give you a firm price before any work starts, so you're never guessing. If repair is the smart move, we'll say so. If the tank is near the end, we'll explain why and what the replacement looks like.

When replacement is the better call, we often install a new Rheem tank the same day, and we bring the parts on the truck. Homes off State Road 436 are usually a short drive from our shop on East Colonial Drive.

Why does it help to have one plumber handle the gas and the repair?

Because the problem often sits right where the water heater meets the gas line. The valve, the shutoff, the flex connector, and the venting all have to work together. One licensed company handling both means nothing gets missed between trades.

Our gas-licensed technicians check the line and shutoff valve, repair or replace the parts, and pressure test the system before we leave. When a gas line needs a permit, we pull it as part of the job. You can read more about our gas services, from appliance hookups to leak repair.

We've served Seminole and Orange County homes since 1970, and our team averages more than 15 years with the company. That's a lot of pilot lights. See our Altamonte Springs plumbing page for the local work we do every week.

Tired of relighting that pilot? Call Herrell Plumbing at (407) 273-6260 to schedule your gas water heater repair, or schedule service online and we'll get a licensed plumber out to you.

Share this postFacebookXLinkedIn
Get a Free Estimate